- 您现在的位置：买卖IC网 > Sheet目录17338 > EL7554IRE-EVAL (Intersil)DEMO BOARD FOR EL7554
EL7554
Waveforms
(Continued)
V IN = V D = 3.3V, V O = 1.8V, I O = 4A, L = 2.2μH, C IN = 2x10μF, C OUT = 47μF, C OSC = 220pF, T A = +25°C unless otherwise noted.
V IN (2V/DIV)
V IN (5V/DIV)
I IN (2A/DIV)
T D = C EN × --------------------
V O (1V/DIV)
C IN = 100μF,
C OUT = 150μF
2ms/DIV
FIGURE 18. ADJUSTABLE START-UP
Detailed Description
The EL7554 is a full-feature synchronous 6A step-down
regulator capable of up to 96% efficiency. This device
operates from 3V to 6V V IN input supply. With internal
CMOS power FETs, the device can operate at up to 100%
duty ratio, allowing for output voltage range from 0.8V up to
nearly V IN .The adjustable high switching frequency of up to
1MHz enables the use of small components, making the
whole converter occupy less than 0.58 square inch with
components on one side of the PCB. The EL7554 operates
at constant frequency PWM mode, making external
synchronization possible. Patented on-chip resistorless
current-sensing enables current mode control, which
provides over-current protection, and excellent step load
response. The EL7554 features soft-start and full start-up
control, which eliminate the in-rush current and enables
users to control the start-up of multiple converters to any
configuration with ease. The EL7554 also offers a ±5%
voltage margining capability that allows raising and lowering
of the supplies derived from the EL7554 to validate the
performance and reliability of system cards quickly and
easily during manufacturing testing. A junction temperature
indicator conveniently monitors the silicon die temperature,
saving designers time in the tedious thermal
characterization.
Start-Up
The EL7554 employs a special soft-start to suppress the in-
rush current (see Figure 12). The start-up process takes
about 2ms and begins when the input voltage reaches about
2.8V and EN pin voltage 2V. When EN is released from
LOW, or the converter comes out of thermal shut-down
mode, the soft-start process repeats. When the input voltage
ramps up too slowly, slight over- current at the input can
allows 100% turn-on of the upper PFET switch, achieving
9
V O1 =2.5V
V O2 =1.8V
C IN = 100μF,
C OUT = 150μF
5ms/DIV
FIGURE 19. TRACKING START-UP
occur. Connecting a small capacitor at EN will delay the
start-up. The delay time T D can be calculated by:
V EN_HI
I EN
where:
? C EN is the capacitance at EN pin
? V EN_HI is the EN input high level (function of V DD voltage,
see Figure 5)
? I EN is the EN pin pull-up current, nominal 2.5μA
If a slower than 2ms soft start-up is needed, please refer to
Full Start-Up Control section.
Steady-State Operation
The converter always operates at fixed frequency
continuous-conduction mode. For fast transient response,
peak current control method is employed. The inductor
current is sensed from the upper PFET. This current signal,
the slope compensation, and the compensated error signal
are fed to the PWM comparator to generate the PWM signal
for the internal power switches. When the upper PFET is on,
the low-side NFET is off and input voltage charges the
inductor. When PFET is off, the NFET is on and energy
stored in the inductor is dumped to the output to maintain
constant output voltage. Therefore, the LX waveform is
always a stable square waveform (see Figure 13) with peak
close to V IN . So LX is a good indication that the converter is
operating properly.
100% Duty Ratio
EL7554 uses CMOS as internal synchronous power
switches. The upper switch is a PMOS and the lower switch
an NMOS. This not only saves a boot capacitor, it also
FN7360.5
November 5, 2007
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
ASPI-0630LR-6R8M-T15
INDUCTOR POWER 6.8UH 0630 SMD
A9CCG-1008F
FLEX CABLE - AFG10G/AF10/AFG10G
TARS336M006
CAP TANT 33UF 6.3V 20% AXIAL
EBC07DRAI
CONN EDGECARD 14POS R/A .100 SLD
RCM15DCSN-S288
CONN EDGECARD 30POS .156 EXTEND
TARS335K035
CAP TANT 3.3UF 35V 10% AXIAL
TH3D226M025E0600
CAP TANT 22UF 25V 20% 2917
EEC20DREN-S13
CONN EDGECARD 40POS .100 EXTEND
相关代理商/技术参数
EL7554IRE-T13
功能描述:IC REG BUCK SYNC ADJ 4A 28HTSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR
EL7554IRE-T7
功能描述:IC REG BUCK SYNC ADJ 4A 28HTSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR
EL7554IREZ
功能描述:直流/直流开关调节器 LDFREE 7554 6 AMP DC:DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
EL7554IREZT13
制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Monolithic 4 Amp DC-DC Step-Down Regulator
EL7554IREZ-T13
功能描述:直流/直流开关调节器 LDFREE EL7554 6 AMP DC:DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
EL7554IREZ-T7
功能描述:直流/直流开关调节器 LDFREE EL7554 6 AMP DC:DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
EL7556AC
制造商:ELANTEC 制造商全称:ELANTEC 功能描述:Programmable CPU Power Supply Unit
EL7556ACM
制造商:ELAN 功能描述: